eFlow v0.0.1 is complete. Please consider this as Beta software. It has been tested to assure that the functions behave as expected, though boundary tests have not been completed. That will begin in the v0.0.2 firmware. Features Network Admin Mode to set the SSID and IP address Realtime view of process conditions in your reflow oven Ability to export the process…
Read MoreCategory: Internet of Things
eFlow Hardware v0.0.1
eFlow Hardware v0.0.1 eFlow is exceedingly easy to assemble (No part smaller than 0603) and requires no difficult to source components. Circuit Bill of Materials 1 x 10uf 0603 Capacitor (C1) 2 x 1uf 0603 Capacitor (C2, C3) 2 x 0.01uf 0603 Capacitor (C4, C5) 4 x 3.3k ohm 0603 Resistor (R3, R4, R5, R6) 3 x Terminal Block, 2…
Read MoreeFlow – The Wifi Reflow Oven Controller
eFlow – The Wifi Reflow Oven Controller Back in 2005 I begun assembling hobby circuits using surface mount components and in 2006 built(ish) my first reflow oven. I say built(ish) because other than using writing “Not for food” on the door with a sharpie and using thermocouple attached to an inexpensive multimeter, there was nothing else modified. A decade later,…
Read MoreYado – A Secure Door Opener
There’s been many DIY IoT garage door openers but none of them offered the level of security that is required to secure my home. While it’s true that most are “good enough” placed behind a secure Wifi router, that level of security is unacceptable for a device that is on the publicly facing internet. I trust this device enough where the URL…
Read More